Continued from Part 2 of Change Your Own Oil and Save Cash…

STEP SEVEN: O.K., you’re back. Put your gloves on and get to work. Before you thread the new oil filter in place, dip a finger into the drain pan and coat the rubber gasket on the bottom of the filter with oil, and set it aside. This will help it seat better against the engine block. With a clean rag, wipe off the round metal circle on the engine where the oil filter fits, then thread the new filter onto the post. When it’s finger-tight, either tighten it by hand if you’re strong enough (it takes about one-half to three-quarters of a turn, no more: read the instructions on the filter), or flip the oil filter wrench over on the socket wrench and tighten it that way.

STEP EIGHT: We recommend using a new sealing washer on the drain plug. Put the washer in place and thread the drain plug back into its hole. Scooch it up tight with the socket set, but not so tight that you can’t get it off the next time (remember your struggles earlier; better to have it snug but not stripped.) Now take the oil drain pan and the empty milk bottle and the funnel. If you have a friend, have him hold the bottle while you pour the oil into it. When most of the oil has found the bottom of the bottle, seal it with the lid, then wipe out the inside of the funnel with a clean rag. (We sometimes prop the drain pan against a wall and let it continue to drip into the bottle while we do the next step. You’ll need an extra funnel to do this.)

STEP NINE: Set the cleaned funnel into the oil filler hole and pour in as many quarts as the manufacturer recommends. As the oil fills, begin cleaning up. Throw the newspapers in the trash and wipe down all your tools. Discard the empty oil containers in a recycling bin. After the oil is all in, twist the oil cap back on and check the dipstick for oil level, just to make sure. Take the old oil filter, place it in the Ziploc bag, and seal it.

STEP TEN: Start the engine and let it idle for about five minutes, looking for leaks. Place the milk container and the Ziploc bag in a box, and set it somewhere in the car where it can’t tip over. Drive to the nearest oil recycling center (as we discussed, most of the national chains, such as Econo Lube N’ Tune, Jiffylube, Grease Monkey, etc., will take your old oil and filters). Take a last look underneath for leaks.

Greg Chapman of Greg Chapman Motors is a knowledgeable and leading provider of used cars, trucks, and SUV’s. Since 1959, Chapman motors has supplied reliable used cars in Austin and the surrounding area and is known as one of the bad credit car dealers in Austin. For more information please visit http://www.gregchapmanmotors.com.

Article Source:http://www.articlesbase.com/automotive-articles/change-your-own-oil-and-save-some-cash-838149.html